cool... Bonus question, can it run in reverse? BIG bonus question, can it backtrack more than a single move ;-)))
Seriously though I can set up use cases for these. EBo -- On Jan 18 2017 5:35 AM, andy pugh wrote: > Users, eh! > > I told someone that run-from-line with arcs was difficult, but rather > than believe me, he found a way to alter the source code to make it > work. > > > https://forum.linuxcnc.org/38-general-linuxcnc-questions/32148-radius-to-end-differ-from-radius-to-start-error-during-stop-run-from-line#85804 > > This actually sounds like a fairly good modification. > > -- > atp > "A motorcycle is a bicycle with a pandemonium attachment and is > designed for the especial use of mechanical geniuses, daredevils and > lunatics." > — George Fitch, Atlanta Constitution Newspaper, 1916 > > > ------------------------------------------------------------------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, SlashDot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-developers mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-developers ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
