The G codes in the ini file are only in effect at start up as soon as you change them they are gone.
JT On 1/26/2017 6:51 AM, Gene Heskett wrote: > On Thursday 26 January 2017 07:00:55 andy pugh wrote: > >> Someone on the forum just noticed that, even on a lathe, where it >> makes no sense, M2 resets to the XY plane. >> >> Is this really correct behaviour? > I've noticed that too, Andy. I don't think it should be, but I just put > the G18 into my code before the arc and kept on trucking. It wasn't a > showstopper for me at the time. What did surprise me was that I had the > G18 in the .ini files rs274 line of initializing gcodes and it still > needed it in the gcode file. T'weren't no biggie, so I never barked > about it. > > Cheers, Gene Heskett ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-developers mailing list Emc-developers@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-developers
