On 02/25/2017 01:29 PM, Jon Elson wrote: > Over the years, it has been seen that certain parallel port > chips did not work properly with my hal_ppmc driver. > And, another question :
I have a development system that was built at Tx/Rx Labs in Houston with help from Jeff Epler. It uses the : 3.2.0-4-rt-686-pae #1 SMP PREEMPT RT Debian 3.2.82-1 i686 kernel, but the LinuxCNC version is a BIT dated. Is this kernel OK to pull and build a source git repo for updating this driver? I know there have been a LOT of changes in LinuxCNC since I had this local repo current. Thanks, Jon ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-developers mailing list Emc-developers@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-developers