>
>
But I didn't get very far:
pi@raspberrypi:~/linuxcnc/configs/sheldon-lathe $ halrun
halcmd: loadusr metric_status
halcmd: Traceback (most recent call last):
File "/usr/local/bin/metric_status", line 16, in <module>
GSTAT.connect("metric-mode-changed",mode_changed)
TypeError: <GStat object at 0x76a9df80 (hal_glib+_GStat at 0xd09500)>:
unknown signal name: metric-mode-changed
halcmd: show pin
Component Pins:
Owner Type Dir Value Name
halcmd:
Something didn't work, but me python dummy.
I thought I was following directions from the link?
Thanks Chris.
Cheers, Gene Heskett
-
Probably not current enough then.
looks like it was added march 21 or so.
Use Kurts version (but i would set the rate at minimum 100ms instead of 50.
Chris M
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
