Greetings everybody; Playing around with lathe-pawn.ngc, trying to add the G96 CSS commands to it so while it might not be spot on, it at least demo's that it works, and I have that, although the rev ceiling in 1st gear gets in the way, it does work.
But the canary died: However, while I can re-run the code if it runs to completion, and it will do it correctly a 2nd time, I can't stop it, and edit the code (or do an x touchoff to get the nachine closer to the real centerline 0 ) and then reload the edited code as it claims there is not an Svalue in the G96 line. Except it fusses about line 0. And the G96 is in line 6. Shutting down LinuxCNC and then launching it again lets me reload the code w/o any fussing. And it runs correctly. It fusses about it after a touch-off, but I can hit r to run it, and it runs with the machine moving in the correct space, but drawing the backplot about 10cm inward from the white code scan trace in the backplot. This is: /var/cache/apt/archives/linuxcnc-uspace-dev_1%3a2.8.0~pre1.3155.ga8df216_armhf.deb /var/cache/apt/archives/linuxcnc-uspace_1%3a2.8.0~pre1.3155.ga8df216_armhf.deb Thanks everybody, I gotta go cook, or go out, depends on what the missus wants. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
