It was meant for current PCB, placing 2 resistors instead of one (one end of resistors SMD pad, second connected 'in air') ..
On Thu, Aug 24, 2017 at 3:53 AM, Jon Elson <el...@pico-systems.com> wrote: > On 08/23/2017 01:01 PM, Petr Ledvina wrote: > >> John, >> One way to improve power dissipation a bit is to mount two resistors in >> series instead of one, forming inverted V ... It's not that ugly and will >> add some margin to available power dissipation.. >> >> >> I might do that for the next PCB revision. Right now, on existing > boards, I can fit a 2 W resistor on the same pads, but don't know if it > will help much on the overall heating. The 2W resistor will most likely > have more resistive material in it, so it might run a little cooler. > > > Jon > > ------------------------------------------------------------ > ------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-developers mailing list > Emc-developers@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-developers > -- Ing. Petr Ledvina ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-developers mailing list Emc-developers@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-developers
