Hi
I asked this on the EMC list but thought it should be more relevant
here.
I need to write a custom RS-422 protocol to control a plasma cutter. I
have a mesa 7i44 (amongst other's ) on the system.
I have never used or seen any examples of how to communicate to custom
hardware via the RS-422 on the mesa cards. Is there anyone out there
that has some examples that I can look at to get started please?
Or some advise will do as well thanks.
-----------------------------
Regards / Groete
Marius D. Liebenberg
+27 82 698 3251
+27 12 743 6064
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
