Thanks a lot Alexander. That looks like the right thing.
Do you have a snippet that shows how to instantiate and connect?
------ Original Message ------
From: "Alexander Rössler" <[email protected]>
To: "Marius Liebenberg" <[email protected]>; "EMC developers"
<[email protected]>
Sent: 2017-09-21 18:10:38
Subject: Re: [Emc-developers] Mesa RS-422 hal example
Hello Marius,
The PktUart HAL driver should work for you. I implemented something
similar recently. There is an example in the Machinekit sources.
Best regards,
Alexander
Marius Liebenberg writes:
Hi
I asked this on the EMC list but thought it should be more relevant
here.
I need to write a custom RS-422 protocol to control a plasma cutter.
I
have a mesa 7i44 (amongst other's ) on the system.
I have never used or seen any examples of how to communicate to
custom
hardware via the RS-422 on the mesa cards. Is there anyone out there
that has some examples that I can look at to get started please?
Or some advise will do as well thanks.
-----------------------------
Regards / Groete
Marius D. Liebenberg
+27 82 698 3251
+27 12 743 6064
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
--
Alexander Rössler
[email protected]
+43 680 1348338
Lebnergasse 1/7/7
1210 Wien - Austria
ATU72251528
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
