Gene, This should clone master (which is 2.8~pre):
git clone https://github.com/LinuxCNC/linuxcnc.git linuxcnc-dev Is that what you need? Cheers, Kurt On Mon, Oct 9, 2017 at 3:08 PM, Gene Heskett <ghesk...@shentel.net> wrote: > I don't know if the sd card is going or what, but I just did a make > clean; make in linuxcnc-dev/src, and halui.cc seems to have blown up, > megabytes of error messages, none of which actually stopped the build. > > I have rotating media on that rock64, so I'll put this pull on it just > for S&G. > > Cheers, Gene Heskett > -- > "There are four boxes to be used in defense of liberty: > soap, ballot, jury, and ammo. Please use in that order." > -Ed Howdershelt (Author) > Genes Web page <http://geneslinuxbox.net:6309/gene> > > ------------------------------------------------------------ > ------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-developers mailing list > Emc-developers@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-developers > ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-developers mailing list Emc-developers@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-developers