Hello, congratulations on a super program the LinuxCNC!
I wanted to ask if you can implement a function that segment the tool path and make LinuxCnc to run only this segment a little bit deeper. PCB is one example for where it is needed. When the PCB is not perfectly flat. You look at the isolation path on the PCB and decide which part has not been wide or deep enough to isolate electricity and re-run this part. If I could select and highlight the part of the path myself it would be very nice. When I attach a pen to my machine and the writing is not everywhere the same thickness, I would like to have this function too. Where I can make the program to run certain regions of the toolpath to make the appearance even. Or is there a patch where this function already can be installed? Many thanks and best regards Tom ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
