Hi all,
sorry, my english is not so good. I use Linuxcnc since about 2007, try
to get more experience since...
I mention it before on "Emc-users Digest, Vol 98, Issue 58"
The idea is that you start you machine, home it , do some mill action or
jog around and than when press the "home" bottom again, then pops out a
window: "Axis is already homed, are you sure you want to re-homed?"
if you then press "yes" the Machine do the home sequence again and tell
you with a pop-window something like: " your home location now has a
difference of 0.2xx from the last time of your home position"
or "the home switch location is 0.3mm away from the expect location"
I now there must a way to do this, but didn't i figured it out till get.
I would be so helpful for low budged Machines to get the maximum speed
and acculation. I know that the "prusa 3D printer" can do something
similar.
Thanks a lot for your passion!
Chris
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
