On 02/18/2018 12:16 PM, Jon Elson wrote: > I have built a system running a 64-bit Debian 8 (Jessie), and have the > preempt RT kernel running. > Is it possible to put LinuxCNC (non-simulation) on this? Is there a > pre-compiled binary, or would it > have to be compiled from source?
Yes it's possible, it works well and is one of the supported platforms. The buildbot's "sim" jessie debs are actually built for uspace, the naming is a misleading anachronism. Use the apt source line from here: http://buildbot.linuxcnc.org/ Pick the one that says "Jessie (uspace: realtime with RT-Preempt, and simulation)". -- Sebastian Kuzminsky ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
