On 27 June 2018 at 04:02, Gene Heskett <[email protected]> wrote: > As long as I had the i/o pins, available, it makes sense that in mounting > the tool or the part, if I could just flip a switch to enable the > drilling for the grub screws, or another to enable the tapping of the > holes just drilled
I don't think that there is any point going through hardware for this. A G-code file can read HAL values from a PyVCP or GladeVCP panel and react accordingly (the values are only valid at program start, but that's fine here). -- atp "A motorcycle is a bicycle with a pandemonium attachment and is designed for the especial use of mechanical geniuses, daredevils and lunatics." — George Fitch, Atlanta Constitution Newspaper, 1916 ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
