Hello all, I posted this earlier to the emc users list so this is technically a cross post. Hopefully this is not a problem. If there is an issue, please let me know and I will refrain from cross posting in the future.
My earlier posts were about the parallel port docs located at http://linuxcnc.org/docs/2.7/html/hal/parallel-port.html, in which there is a table describing the parallel port pins for a given mode, "IN", "Out" or "x". I believe that pin 14 on the "IN" column is incorrect and should read out rather than in. If I am correct, can the documentation be edited. The message below is what I posted to the users group, and the video link below is what I created to show why I think I am correct. Now having said that, if I am incorrect would someone try to explain to me why I am wrong? ========= I think I done a poor job of explaining my question, although I believe Andy Pugh got it. I created a video demonstrating what I mean, although not the best presentation. Was wondering if someone would correct my mis-information or confirm what I think to be true. If I am correct, can we get it changed in the documentation. Here is the video [ https://www.youtube.com/watch?v=QE6tW6W_5Po | https://www.youtube.com/watch?v=QE6tW6W_5Po ] I am sorry if I am being a pain in the a$$ Regards, Joe ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
