Sorry you are in right IS MY ERROR the right file is emccfg.h and emcglb.h and nml_io.hh .... so i find it on my linuxcnc-dev folder ... Real sorry .... Not copy the xemc.cc fine in 2.8 Lcnc yet and so not test it .... but as I see all these file is the same to the last 2.6 version (when xemc was avaiable).
but ... The big question before to start ... Is there any reason, which I do not see now, so it is not recommended to use xemc as a basis for my project?? Note: my ideas is clean xemc to all x11 call and insert signal/slot mechanism typical of QT c++ syntax. At these point QtXemc become a qthread in my ideas, and every type of custom interfaces become possible using Qt because all motion and halui pin become avaiable for a GUI. Does anyone not recommend this approach to things? Regards bkt Il giorno lun 10 set 2018 alle ore 13:56 andy pugh <[email protected]> ha scritto: > On Sat, 8 Sep 2018 at 09:30, theman whosoldtheworld > <[email protected]> wrote: > > > in my linuxcnc-dev folder not found : emcglb.hh, emccfg.hh, nml_io.hh > only > > Are you sure about the first two? I can find emcglb.h and emccfg.h but > not the .hh > xemc.cc references the .h files. > > nml_io.hh is in src/libnml/nml/nml_oi.hh > > -- > atp > "A motorcycle is a bicycle with a pandemonium attachment and is > designed for the especial use of mechanical geniuses, daredevils and > lunatics." > — George Fitch, Atlanta Constitution Newspaper, 1916 > > > _______________________________________________ > Emc-developers mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-developers > _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
