I think this link https://upload.wikimedia.org/wikipedia/commons/thumb/3/3e/Linux_graphics_drivers_Utah_GLX.svg/560px-Linux_graphics_drivers_Utah_GLX.svg.png show arhitecture.
X11 have an advantage it could be used over the network. Application could be run on any computer for example a powerful server stored in cellar or there heat i needed and server is run on computer with a display. X11 is normally used on Linux so it and is usually ready for use via SSH in Linux but enable X11 forwarding flag may be necessary. Server is also available for free for windows and it is very practical then having a file server somewhere. Do anybody have enough insight into X11 protocol to tell if running linuxcnc X11 client on computer without display and X11 server on any ordinary computer might be a good idea? Do anybody know if current version of QT or GTK which I think are the most common support rendering on Linux framebuffer hardware abstraction layer? Are the Linux framebuffer hardware abstraction layer usually available? Nicklas Karlsson > https://www.youtube.com/watch?v=qyyjcHG_G4M > > For embedded systems, writing direct to the framebuffer (apparently) > and written in C. > > Details here: > https://forum.linuxcnc.org/41-guis/35225-new-gui-for-embedded-systems?start=0#117403 > > -- > atp > "A motorcycle is a bicycle with a pandemonium attachment and is > designed for the especial use of mechanical geniuses, daredevils and > lunatics." > — George Fitch, Atlanta Constitution Newspaper, 1916 > > > _______________________________________________ > Emc-developers mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-developers _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
