Hi all, yesterday I published a new driver version for Arduino/Raspberry (raw-eth) and a little README.
http://erste.de/ethraw/README It is a short version of this one: http://erste.de/ethraw/readme.de.html And it is also included in this archive: http://erste.de/ethraw/linuxCNC.ethraw.tgz the driver supports also step_type 15 (quadratur-signal) - but (only on the raspberry for now). I will check out the technical limits of both devices in the next days.... I would be fine, if somebody can take a look on the package and give me some feedback. Especially about the english "README" - you may notice, this is not my motherlanguage .... ;-) regards wicki _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
