Hello all,
Mesa 6i25/7i76 combo fitted into an intel i3 It's only the PC sitting in the office, no drivers etc. connected yet. I made a fresh install. debian 10 rt-preempt linuxcnc 2.8 from stable repository worked great ... Then I took a config I had, which is a gantry config XYYZ when I start axis, just press home for each joint then move X Y and Z Z moves fine, X and Y move in the wrong direction other than that, X when it moves positive, it runs fine, negative it runs a fraction of a sec and stall's with machine disabled just like a following error, but no error shows up. I'm used to see that little boxes on the lower right corner of axis that say's following error. Any advice? Ju _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
