On 10/16/25 18:09, gene heskett wrote:
Hi all;
I've an odd problem. One that refreshed my CET card a bit. I have an
and2 module that isn't and-ing, yet its ok in the hal files loadrt
section and in the addf list. But with both inputs true, the output is
still false, so my spindle's pid_s is never enabled. Bit rot, alpha
hit maybe? No errors reported when restarting Linuxcnc-2.10-pre. on a
bullseye system. It worked fine for over a decade until 10 yo shoe-goo
migrated and locked a tally switch in the off position, so I designed
a new switch holder, printed it and installed it. Works as expected
for what it was intended to do. That wiring isn't anywhere near this
failure in the logic path..
How is the best way to fix this?
False alarm. And my apologies. I found that somehow, in commenting out
axis A stuff since that axis was dismounted and hanging on a bracket
still wired up.. I had also killed the addf for the pid_s enable's and2.
So call the St Bernards back and have a shot I can't, diabetes & all
that. Sorry for the noise & wasted time.
Thanks all.
Cheers, Gene Heskett, CET.
Cheers, Gene Heskett, CET.
--
"There are four boxes to be used in defense of liberty:
soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author, 1940)
If we desire respect for the law, we must first make the law respectable.
- Louis D. Brandeis
Don't poison our oceans, interdict drugs at the src.
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
