On 11/21/25 04:08, andy pugh wrote:
On Thu, 20 Nov 2025 at 22:55, gene heskett <[email protected]> wrote:
Pin 'hal_manualtoolchange.change' does not exist
Presumably hal_manualtoolchange isn't loading. There should be further
clues in the debug output.
This is 2.10-pre running on an old bullseye install
Technically 2.10 isn't supported on anything older than Bookworm. But
that's unlikely to _suddenly_ be the problem.
You went thru a period around late wheezy or buster I think where the
next was going to skip 2. 8&9, and this was last self compiled from that
src quite a few years ago. Then you reverted to start the 2.8 series so
this 2.10-pre is now several years old, at least 6 or 7. Just barely has
some of Rob's work on the planner. And little kin of the current
2.9.7. That is the real src of the confusion. In the meantime I've
reconfigured it many times 3 axis or 4 even 5 once.
Thanks Andy.
Cheers, Gene Heskett, CET.
--
"There are four boxes to be used in defense of liberty:
soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author, 1940)
If we desire respect for the law, we must first make the law respectable.
- Louis D. Brandeis
Don't poison our oceans, interdict drugs at the src.
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
