Lothar,
 
 Of all the DofC's I've witnessed in my travels that have been generated from 
 test labs, very few have required the manufacturer's signature. In fact, they 
 were signed by an officer of the test lab. However, to be fair, these DofC's 
 issued from test labs may be only intended for and addressed to the approval 
 holder/manufacturer to demonstrate conformance for a particular compliance 
 achievement (e.g., EN55022, EN50082-1, CTR4, etc.).
 
 Conversely, the manufacturer's DofC must encompass all applicable compliances 
 pertaining to a particular product. In which case the manufacturer is 
 duty-bound to generate and sign it.
 
 Just some addtional views on the subject.
 
 Comments are welcome.
 
 Best regards,
 Ron Pickard
 [email protected]


______________________________ Reply Separator _________________________________
Subject: AW: Declaration of Conformity  
Author:  "Schmidt  Lothar" <[email protected]> at INTERNET
List-Post: [email protected]
Date:    5/28/99 7:37 AM


Hi Richard,
 
just one comment to Ron Pickard. The DoC could be gernerated by the lab 
but, have to be signed be the manufacturer.
 
Best Regards
 
Lothar Schmidt
Competent Body / New Services
CETECOM ICT Services GmbH
Tel.:        +49 (0) 681 598-8723
Fax:        +49 (0) 681 598-8775 
e-mail: [email protected]
 
http://www.cetecom.de
 
 
 
> -----Ursprüngliche Nachricht-----
> Von:        [email protected] [SMTP:[email protected]] 
> Gesendet am:        Freitag, 28. Mai 1999 01:26
> An:        [email protected]; [email protected] 
> Betreff:        Re: Declaration of Conformity 
> 
>  
> 
>  Hi Richard,
>  
>  To answer your question, I would like to refer you to EN45014:1993, 
> entitled 
>  "General criteria for the suppliers' declaration of conformity" (a 
> newer 
>  version may exist). Section 5 details the minimum contents of the 
> DofC. Annex A 
>  provides a recommended sample DofC. I believe this standard serves as 
> the 
>  normative basis for the DofC's that accredited test labs generate and 
> should 
>  apply to suppliers, as well.
>  
>  As to your other points, I can only say this. The DofC should be 
> clear to what 
>  is being declared. Keep it simple, but complete and as descriptive as 
> possible.
>  
>  I hope this helps.
>  
>  Best regards,
>  Ron Pickard
>  [email protected]
> 
> 
> ______________________________ Reply Separator 
> _________________________________
> Subject: Declaration of Conformity 
> Author:  "WOODS  RICHARD" <[email protected]> at INTERNET 
> Date:    5/27/99 3:21 PM
> 
> 
>  
> I am in the process of revising our EU DoCs and would like to hear 
> from the 
> group as to what information is minimally required by law concerning 
> the 
> harmonized standards. The declarations that I have seen vary in 
> content and 
> fall into the following categories; 
>  
> *        Standard numbers only
> *        Numbers and dates
> *        Numbers, dates and revisions and dates
> *        Family standards listed but no listing of the standards required 
> by 
> the family standard
> *        Family and referenced standards listed 
> *        Class of emissions (A or B)
> Are dates required? Are revisions required? Must the standards 
> referenced in 
> the family standard be listed? Must the class of emissions be listed? 
>  
> Again, I trying to determine the minimal content required by law. 
>  
> ---------
> This message is coming from the emc-pstc discussion list.
> To cancel your subscription, send mail to [email protected] 
> with the single line: "unsubscribe emc-pstc" (without the 
> quotes).  For help, send mail to [email protected], 
> [email protected], [email protected], or 
> [email protected] (the list administrators). 
>  
>  
>  
> 
> 
> ---------
> This message is coming from the emc-pstc discussion list.
> To cancel your subscription, send mail to [email protected] 
> with the single line: "unsubscribe emc-pstc" (without the
> quotes).  For help, send mail to [email protected], 
> [email protected], [email protected], or
> [email protected] (the list administrators). 
> 
 


---------
This message is coming from the emc-pstc discussion list.
To cancel your subscription, send mail to [email protected]
with the single line: "unsubscribe emc-pstc" (without the
quotes).  For help, send mail to [email protected],
[email protected], [email protected], or
[email protected] (the list administrators).

Reply via email to