I've got some toroids sitting on the bench (about 2 inches in diameter) that
would accomodate that with around 20 turns of doubled up 12 Awg wire.
You need them?
- Robert -
-----Original Message-----
From: Derek Walton <[email protected]>
To: [email protected] <[email protected]>
List-Post: [email protected]
Date: Wednesday, October 06, 1999 6:47 PM
Subject: Inductor
>
>Hi folks,
>
>I need a low cost inductor with the following specifications:
>
>100 microhenry, 30 amp max., operating frequency range 150 to 250 kHz
>max.
>
>The rest is open for grabs. An air-core, while cheap enough, is a little
>large. So I'm thinking about a few turns of heavy wire on a bar. Any
>suggestions of what this bar should be mad of?
>
>Thanks,
>
>Derek.
>--
>Derek Walton
>Owner
>L. F. Research EMC Design and Test Facility
>12790 Route 76,
>Poplar Grove,
>IL 61065.
>www.lfresearch.com
>
>
>
>---------
>This message is coming from the emc-pstc discussion list.
>To cancel your subscription, send mail to [email protected]
>with the single line: "unsubscribe emc-pstc" (without the
>quotes). For help, send mail to [email protected],
>[email protected], [email protected], or
>[email protected] (the list administrators).
>
>
---------
This message is coming from the emc-pstc discussion list.
To cancel your subscription, send mail to [email protected]
with the single line: "unsubscribe emc-pstc" (without the
quotes). For help, send mail to [email protected],
[email protected], [email protected], or
[email protected] (the list administrators).
