Hi Kevin, You may want to take a look at the SE-300-2-2 from thermotron check it out at this link http://www.thermotron.com/sechamber.html. We have one here and its so far so good. I did have one problem with it initially but the folks at thermotron took care of it quite promptly and I have had no further problems.
It does have remote capabilities (You need to buy a card from thermotron and then they give you the software for free). I have found the temperature control to be very tight but the humidity reacts quite slow. If you wanted faster drops in humidity I think thermotron could set you up with a dry air purge option. The unit is spec'd to perform tests in accordance with a number of IEC standards, a couple are pre-programmed and others you can program yourself. I will say that the profile programming of this unit is impressive and I believe you can write profiles at your desk and then load them through the remote access or floppy drive if you go with that option. All things considered I am pleased with the unit. Good luck! Jeff Bailey EMC Technologist SST Division of Woodhead Canada Phone: (519) 725 5136 ext. 363 Fax: (519) 725 1515 Email: [email protected] Web: www.sstech.on.ca -----Original Message----- From: Kevin Harris [mailto:[email protected]] Sent: Wednesday, May 12, 1999 12:03 PM To: EMC-PSTC (E-mail) Subject: Request for Environmental Chamber Info for North American Market Hi Folks, Well it is time for me to get a new environmental chamber. I need a unit with temperature and humidity control and also automated control from a computer. We are looking for a capacity in the 8 cubic foot range. Does anyone have some manufacturer names and model numbers for a chamber they have used and liked or perhaps some info on units to stay away from (perhaps it would be better for the second part to be offline). Thank you Best Regards, Kevin Harris Manager, Approval Services Digital Security Controls 1645 Flint Road Downsview, Ontario CANADA M3J 2J6 Tel +1 416 665 8460 Ext. 2378 Fax +1 416 665 7753 email: [email protected] --------- This message is coming from the emc-pstc discussion list. To cancel your subscription, send mail to [email protected] with the single line: "unsubscribe emc-pstc" (without the quotes). For help, send mail to [email protected], [email protected], [email protected], or [email protected] (the list administrators). --------- This message is coming from the emc-pstc discussion list. To cancel your subscription, send mail to [email protected] with the single line: "unsubscribe emc-pstc" (without the quotes). For help, send mail to [email protected], [email protected], [email protected], or [email protected] (the list administrators).
