Hi All, For those of you who like to tinker in the lab (and sometimes we have to when the right equipment is not available), this month's Technical Tidbit (at http://www.dsmith.org near bottom of index page) describes how to make a shielded magnetic probe out of common materials (no semi-rigid coax needed). Such a probe is useful in many signal integrity and EMC investigations. Some uses for such probes are discussed in the paper on the site at
http://www.dsmith.org/pdf/emc99-w.pdf titled "Signal and Noise Measurement Techniques Using Magnetic Field Probes." Last month's Technical Tidbit showed how to measure ESD induced interference inside of equipment using a magnetic field probe. Doug -- ------------------------------------------------------- ___ _ Doug Smith \ / ) P.O. Box 1457 ========= Los Gatos, CA 95031-1457 _ / \ / \ _ TEL/FAX: 408-356-4186/358-3799 / /\ \ ] / /\ \ Mobile: 408-858-4528 | q-----( ) | o | Email: [email protected] \ _ / ] \ _ / Website: http://www.dsmith.org ------------------------------------------------------- ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Jim Bacher: [email protected] Michael Garretson: [email protected] For policy questions, send mail to: Richard Nute: [email protected]
