I believe you are correct. Telcordia has a slew of other component
performance documents on the subject. I don't know of any compliance
standards that apply to the passive items, active obviously another issue.
Gary
-----Original Message-----
From: Gorodetsky, Vitaly [mailto:[email protected]]
Sent: Monday, November 27, 2000 6:32 PM
To: 'Maxwell, Chris'; 'EMC-PSTC Internet Forum'
Subject: RE: Passive fiber optic components
The IEC has circulated for comments 86B/1385/FDIS, Fiber Optic
Interconnecting Devices and Passive Components - Basic Test and Measurement
Procedures for Attenuation and 86B/1386/FDIS, Fiber Optic Interconnecting
Devices and Passive Components - Basic Test and Measurement Procedures for
Attenuation and Return Loss. I believe these documents cover performance
evaluation procedures rather than "components compliance".
Vitaly Gorodetsky
The suitability of this information for making decision is solely with the
reader
-----Original Message-----
From: Maxwell, Chris [SMTP:[email protected]]
Sent: Monday, November 27, 2000 1:11 PM
To: 'EMC-PSTC Internet Forum'
Subject: Passive fiber optic components
All,
I was asked by one of my colleagues here if there are any compliance
requirements for passive fiber optic components such as:
patchcords,
connector adapters ...
My quick answer was "no"; however, the cautious side of me says
that there
may be some EN standard governing these types of components.
Has anyone seen or heard of standards that regulate passive fiber
optic
components?
Chris Maxwell, Design Engineer
GN Nettest Optical Division
6 Rhoads Drive, Building 4
Utica, NY 13502
PH: 315-797-4449
FAX: 315-797-8024
EMAIL: [email protected]
-------------------------------------------
This message is from the IEEE EMC Society Product Safety
Technical Committee emc-pstc discussion list.
To cancel your subscription, send mail to:
[email protected]
with the single line:
unsubscribe emc-pstc
For help, send mail to the list administrators:
Jim Bacher: [email protected]
Michael Garretson: [email protected]
For policy questions, send mail to:
Richard Nute: [email protected]
-------------------------------------------
This message is from the IEEE EMC Society Product Safety
Technical Committee emc-pstc discussion list.
To cancel your subscription, send mail to:
[email protected]
with the single line:
unsubscribe emc-pstc
For help, send mail to the list administrators:
Jim Bacher: [email protected]
Michael Garretson: [email protected]
For policy questions, send mail to:
Richard Nute: [email protected]
-------------------------------------------
This message is from the IEEE EMC Society Product Safety
Technical Committee emc-pstc discussion list.
To cancel your subscription, send mail to:
[email protected]
with the single line:
unsubscribe emc-pstc
For help, send mail to the list administrators:
Jim Bacher: [email protected]
Michael Garretson: [email protected]
For policy questions, send mail to:
Richard Nute: [email protected]
