Raymond, Here you go.
Sharp Edge Tester, Model Set - 50 Technical Engineering Service 140 Rumford Road Kings Park, NY, 11754 516-265-4290 Stephen At 09:11 PM 10/16/00 Monday , Raymond Li wrote: >Stephen, > >I would be grateful if you could provide me with their email address, >telephone number and fax number. > >Thanks, > >Raymond > > > >-----Original Message----- >From: Stephen Phillips [mailto:[email protected]] >Sent: Tuesday, 17 October, 2000 03:42a >To: [email protected]; [email protected]; >[email protected] >Subject: Re:Sharp edge & point > > << File: att1.htm >> > > Raymond, > > We use a device from Technical Engineering >Service, in NY, that has replaceable cylinders >with the tape, indicator, and foam backing pre- >applied - and we bought a virtual lifetime supply >with the finger (40-50). It's a pre-loaded spring >device, and each cylinder can be used many >times. Let me know if you want their address >and phone number. > > Best regards, > Stephen > >At 04:10 PM 10/16/00 Monday , Jim Bacher wrote: >> >>forwarding for: [email protected] >> >>____________________Reply Separator____________________ >>Subject: Sharp edge & point >>Author: "Raymond Li" <[email protected]> >>Date: 10/17/00 1:05 AM >> >>In EN60065 & EN60335 standards, there are no specific methods to determine >>sharp >>edge and point. Should we adapt EN71 toys standard as reference for type >>evaluation? It requires adhesive test tape. Can anyone advise me where I >can >>find the test tape. >> >>Thanks and regards, >> >>Raymond Li >>Omni Source Asia Ltd. >> >>------------------------------------------- >>This message is from the IEEE EMC Society Product Safety >>Technical Committee emc-pstc discussion list. >> >>To cancel your subscription, send mail to: >> [email protected] >>with the single line: >> unsubscribe emc-pstc >> >>For help, send mail to the list administrators: >> Jim Bacher: [email protected] >> Michael Garretson: [email protected] >> >>For policy questions, send mail to: >> Richard Nute: [email protected] >> >> > > > - att1.htm >
