Bob: IEC 825-1 is a document approximately 3/8 inch thick. Its entire content is devoted to answering the question you asked. Unfortunately the answer is totally obscured by the complex and unfamiliar symbols used in the calculations. If you are fortunate enough to find someone on this board to deal with the subject he will become a valuable resource for the rest of us and will have to take out a Visa account to be properly compensated for his willingness to consult. If you are incorporating a laser in one of your products start with the laser component manufacturer and establish a good working relationship with a knowledgeable application engineer from that company. If you are trying to define a measurement technique I would still go to the component manufacturer as a source of guidance. Jim Allan Manager, Engineering Services Milgo Solutions LLC 1619 N Harrison Parkway Sunrise, FL, 33323 E-mail [email protected] Phone (954) 846-3720 Fax (954) 846-5693
> -----Original Message----- > From: Chaplis, Bob [SMTP:[email protected]] > Sent: Friday, October 13, 2000 3:36 PM > To: '[email protected]' > Subject: IEC 825. > > > All, > > I do not have a copy of EN60825-1. Can any body tell me what the > output > radiation level is if it is specified as > " In accordance with IEC 60825-1, 11.93." Any help would be > appreciated. > > > Thank You > > Bob Chaplis > > Genrad > > ------------------------------------------- > This message is from the IEEE EMC Society Product Safety > Technical Committee emc-pstc discussion list. > > To cancel your subscription, send mail to: > [email protected] > with the single line: > unsubscribe emc-pstc > > For help, send mail to the list administrators: > Jim Bacher: [email protected] > Michael Garretson: [email protected] > > For policy questions, send mail to: > Richard Nute: [email protected] > ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Jim Bacher: [email protected] Michael Garretson: [email protected] For policy questions, send mail to: Richard Nute: [email protected]
