I believe that is the correct procedure. I have done so with some of our products on the advice of folks at ITS and Unisys. I have not had any questions from EU importers, thus far.
-----Original Message----- From: Brooks, Barbara [mailto:[email protected]] Sent: Wednesday, August 02, 2000 7:55 AM To: [email protected] Subject: EN 55022 Conducted Emissions I have had an inquiry that I am not sure of the answer and I was hoping that someone could provide me with an answer. If an EUT is DC powered device (i.e., a video card, internal modem, etc.), deriving its power from a host's power supply (i.e., a video card, internal modem, etc.) would the conducted emission specified in EN 55022 be performed on the power leads for the host as part of the test program for the EUT. Thank you for your assistance. Barbara Brooks Wyle Laboratories 7800 Highway 20 West Huntsville, AL 35807-7777 (256) 837-4411 ext 595 (253) 721-0144 Fax [email protected] ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Jim Bacher: [email protected] Michael Garretson: [email protected] For policy questions, send mail to: Richard Nute: [email protected] ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Jim Bacher: [email protected] Michael Garretson: [email protected] For policy questions, send mail to: Richard Nute: [email protected]
