Hello Group,
There are some doubts about some parameters of an EMC receiver that I'd
like to understand better:
- IF bandwith: What it mean/is? How do I set it up? If I have a HF
signal, what IF is better? Or if I have a low freq. signal, what is the
better IF?
- Measurement time: If I don't know (a priori) the noise frequencies,
how do I set the measurement time?
- Frequency Step: What is the step that I should use?
Any comments, URLs, PDFs or tutorials will help.
Thanks in advance for the help and Regards
Muriel
-------------------------------------------
This message is from the IEEE EMC Society Product Safety
Technical Committee emc-pstc discussion list.
To cancel your subscription, send mail to:
[email protected]
with the single line:
unsubscribe emc-pstc
For help, send mail to the list administrators:
Jim Bacher: [email protected]
Michael Garretson: [email protected]
For policy questions, send mail to:
Richard Nute: [email protected]
