Hi Peter.
Check this link. You should be able to find answers to all your
questions there.
http://www.austel.gov.au/standards/index.htm
Regards,
Fabian Spadaccini
TA Instruments, Inc.
(p) 302-427-4189
(f) 302-427-4081
[email protected]
www.tainst.com
-----Original Message-----
From: Peter Merguerian [mailto:[email protected]]
Sent: Thursday, June 08, 2000 9:15 AM
To: [email protected]
Subject: ITE Requirements for Australia
Dear All,
1. For ITE (without a connection to a telecommunication network), what are
the applicable standards and requirements? I assume AS3260 (safety) and
AS3548 (emc) and the manufacturer applies the C-Tick Mark (ie for EMC
Compliance).
2. Is TS001 required or is this standard only used when an equipment is
connected to the telecom network.
3. What is the new RTM Mark for safety and emc? Does this replace the
C-Tick? Where can I download this mark?
4. What is a telecommunication network definition? Is X.25 a telecom
network? Is E1/T1 a telecom network? Where can I get the various interfaces
which are controlled?
5. Does the manufacturer make the declaration of compliance and applies the
mark or does the importer do it? I assume the manufacturer applies the mark
and the importer makes up the declaration.
6. When is the A-Tick Crossed Over Mark used?
Thanks,
Peter Merguerian
Managing Director
Product Testing Division
I.T.L. (Product Testing) Ltd.
Hacharoshet 26, POB 211
Or Yehuda 60251, Israel
Tel: 972-3-5339022 Fax: 972-3-5339019
e-mail: [email protected]
website: http://www.itl.co.il
-------------------------------------------
This message is from the IEEE EMC Society Product Safety
Technical Committee emc-pstc discussion list.
To cancel your subscription, send mail to:
[email protected]
with the single line:
unsubscribe emc-pstc
For help, send mail to the list administrators:
Jim Bacher: [email protected]
Michael Garretson: [email protected]
For policy questions, send mail to:
Richard Nute: [email protected]
