I'm looking for information as to what is required as far as safety testing for a piece of 48 VDC powered ITE Equipment. All outputs will be 12 VDC or less. This is a commercial unit and will not be sold to consumers.
In Europe it would fall outside the scope of the LVD as it starts at 75V for DC powered equipment and this will be powered by 48 VDC. Does anyone know if there any other safety standards required in Europe for this type of equipment? It does appear that safety testing and listing is required by OSHA for use in a U.S. workplace. According to OSHA Standard 1910 Subpart S all "electric utilization equipment" is required to be "approved" which in most cases means Listing by a NRTL. In 1920.399 OSHA defines "electric utilization equipment" as equipment which uses electrical energy for mechanical, chemical, heating, lighting, or similar useful purpose. My interpretation of this is that any equipment which uses electricity, AC or DC, would need to be tested and Listed. Is my interpretation of the OSHA requirements correct? What about requirements for Canada? Any insights into these questions would be greatly appreciated. Thanks, Kurt Andrews Compliance Engineer Tracewell Systems, Inc. 567 Enterprise Dr. Westerville, OH 43081 Ph. 614-846-6175 Fax 614-846-7791 Email: [email protected] ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Jim Bacher: [email protected] Michael Garretson: [email protected] For policy questions, send mail to: Richard Nute: [email protected]
