Hi, No - There is a draft out for IEC 60601-1, 3 edition. The moved the Creepage and Clearances section from Clause 57.10 to Section 19. But, other than some minor editorial changes, they did not change the requirements.
Yes - What they did do is remove from the normative references IEC 60664. Maybe - They now require a "risk management process". See Clause 4.6 in the draft. I suppose you could use the risk assessment to "prove" that the spacing you wanted to use were OK. Ned Devine Entela, Inc. Program Manager III Phone 616 248 9671 Fax 616 574 9752 e-mail [email protected] -----Original Message----- From: Compliance [mailto:[email protected]] Sent: Thursday, May 04, 2000 6:14 PM To: [email protected] Subject: IEC601 - Spacings Requirements All - Is anyone aware of a revision to IEC601 that would affect the creepage and clearance distance requirements? Any details or history would be kindly appreciated. Best Regards, Brent Taira ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Jim Bacher: [email protected] Michael Garretson: [email protected] For policy questions, send mail to: Richard Nute: [email protected] ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Jim Bacher: [email protected] Michael Garretson: [email protected] For policy questions, send mail to: Richard Nute: [email protected]
