forwarded for [email protected].... Jim
____________________Forward Header_____________________
Subject: FW: Protection for Revolving Drum
Author: Israel Yeshurun <[email protected]>
List-Post: [email protected]
Date: 3/2/00 6:59 PM
> Hello group members !
>
> I am looking for a safety device intended for protection against an
> Hazardous Revolving Drum. The drum is enclosed by a protective enclosure
> that is equipped with an access door. I can not use the approach (that
> I think is taken by Washing Machines manufacturers ?) of using a time
> delay solenoid for locking the access door until the drum has stopped.
>
> I would expect the desired device to rely upon measuring of the drum
> revolving speed and compare it to a predetermined (low enough) speed
> value. If the measured speed is low enough the device will operate a
> solenoid that will allow the operator to open the door and get access to
> the drum.
>
> Probably a magnet or other component should be attached to the drum
> surface for this purpose.
>
> And, very Important, we need the device to have safety approvals:
> BSI or VDE or TUV, UL etc.
>
> Many thanks for any contribution !
>
> Best Regards Israel Yeshurun, Product Safety Engineer. Scitex
> Corporation, Israel.
-------------------------------------------
This message is from the IEEE EMC Society Product Safety
Technical Committee emc-pstc discussion list.
To cancel your subscription, send mail to:
[email protected]
with the single line:
unsubscribe emc-pstc
For help, send mail to the list administrators:
Jim Bacher: [email protected]
Michael Garretson: [email protected]
For policy questions, send mail to:
Richard Nute: [email protected]
