Jim, I have always used a label that states: "Demonstration Equipment Only" "Not Tested for Compliance" Regards, Dave Spencer Oresis Communications Compliance Engineer
-----Original Message----- From: Lyons, Jim [mailto:[email protected]] Sent: Thursday, March 02, 2000 2:29 PM To: '[email protected]' Subject: Demo Units Sent to EU w/o CE ? Can anyone tell me if there are provisions for sending prototype electrical equipment to Europe before it has been CE approved? This equipment would normally be subject to the LVD and EMC directive, and would be used at shows to demonstrate the equipment. It is possible that attendies at the show would touch or operate the equipment. Thanks for any comments or insight. Jim Lyons Mgr - Product Compliance GTECH Corp. ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Jim Bacher: [email protected] Michael Garretson: [email protected] For policy questions, send mail to: Richard Nute: [email protected] ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Jim Bacher: [email protected] Michael Garretson: [email protected] For policy questions, send mail to: Richard Nute: [email protected]
