I am tying to figure out what this acutally means when all three of these
terms are used together.
In general I am trying to determine if there is a product specific standard
for EMC compliance for the RTT&E
and
If that document wouldn't happen to be
EN 300 386
Electromagnetic compatibilityand Radio spectrum Matters (ERM);
Telecommunication network equipment;
ElectroMagnetic Compatibility (EMC) requirements;
Part 2: Product family standard
When looking at the surge requirements in 61000-4-5, the Class for
telecommunications products (lets say Class 3) requires higher surge levels
than EN 300 386 (even the new working version). I have not gone through all
the other test documents, but I can only guess that there
are more differences.
Is EN 300 386 the correct spec to use?
best regards,
jim stafford
carrier access corporation
boulder co. 80301
*************************************************************
This email may contain confidential and privileged
material for the sole use of the intended recipient. Any
unauthorized review, use or distribution by others is
strictly prohibited. If you are not the intended recipient
please contact the sender and delete all copies.
*************************************************************
-------------------------------------------
This message is from the IEEE EMC Society Product Safety
Technical Committee emc-pstc discussion list.
To cancel your subscription, send mail to:
[email protected]
with the single line:
unsubscribe emc-pstc
For help, send mail to the list administrators:
Jim Bacher: [email protected]
Michael Garretson: [email protected]
For policy questions, send mail to:
Richard Nute: [email protected]
