In our pre-compliance lab, we've got a pair of LISN's, a LISN-mate type thing that I'll call a DMRN (DM rejection network), a transient limiter, some clamp-on RF current probes, an amplifier, the front end of the analyzer, and a 50 ohm terminator. All this gear is connected and unconnected a hundred times a day when we're deep into trouble-shooting, and I'm sick of doing up and undoing coax connectors. I don't trust push-on coax connectors.
What I envision is a system with a few of these coax switches in it. The analyzer input would go to a switch that selected either the amp (used only with the clamp-on probes) or the transient limiter (used with the LISN's). The limiter input would go to a switch that selected between the output of the DMRN or the Line LISN or the Neutral LISN. Etc. You get the idea. Is there anything to stop me from using coax switches with suitable CW power, insertion loss, and frequency spec's? Am I headed for trouble if I have 2 or 3 of these switches in the signal path, due to cumulative insertion loss? Thanks for your feedback, Regards, Jim Eichner, P.Eng. Manager, Engineering Services Xantrex Technology Inc. Mobile Power web: www.xantrex.com <http://www.xantrex.com> Any opinions expressed are those of my invisible friend, who really exists. Honest. Confidentiality Notice: This email message, including any attachments, is for the sole use of the intended recipient(s) and may contain confidential and privileged information. Any unauthorized review, use, disclosure or distribution is prohibited. If you are not the intended recipient, please contact the sender by reply e-mail and destroy all copies of the original message. -----Original Message----- From: [email protected] [mailto:[email protected]] Sent: Tuesday, May 21, 2002 7:45 AM To: [email protected] Subject: Coaxial Switches Other than Adilent, what are some other sources for low power (<1W) and high power (>100W) coaxial switches for frequencies up to 2 GHz? Richard Woods Sensormatic Electronics Tyco International ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: [email protected] Dave Heald: [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] All emc-pstc postings are archived and searchable on the web at: http://ieeepstc.mindcruiser.com/ Click on "browse" and then "emc-pstc mailing list" ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: [email protected] Dave Heald: [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] All emc-pstc postings are archived and searchable on the web at: http://ieeepstc.mindcruiser.com/ Click on "browse" and then "emc-pstc mailing list"
