Folks,
Is there a standard specifying that the potential ESD hazard Must Be
reduced to a level BELOW 200V ( or other max. voltage ) adjacent to any
location where a customer's Semiconductor Device Under Test might be
Handled or Contacted.
Your comments would be most appreciated.
Best Regards, Paul J Smith
Teradyne, Inc., Boston, MA 02111
[email protected]
-------------------------------------------
This message is from the IEEE EMC Society Product Safety
Technical Committee emc-pstc discussion list.
Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/
To cancel your subscription, send mail to:
[email protected]
with the single line:
unsubscribe emc-pstc
For help, send mail to the list administrators:
Ron Pickard: [email protected]
Dave Heald: [email protected]
For policy questions, send mail to:
Richard Nute: [email protected]
Jim Bacher: [email protected]
All emc-pstc postings are archived and searchable on the web at:
http://ieeepstc.mindcruiser.com/
Click on "browse" and then "emc-pstc mailing list"
