Hi Kirk This is indeed the case, though I would also look at version 1.2.1 and 1.3.1 of EN 301 489-03 that will replace EN 300 683 in august and october next year, to prevent you of doing some double work. Version 1.2.2 will be valid for 2 months only.
Etsi EN 301 489 -03 refers to part 1 for tables and test methods. You will need that too. This standard refers to the product type of standard (her EN 300 220 -3) for EMC aspects of "antenna port" and "enclosure port" only. This standard adresses all other ports of the equipment such as mains, signal and data and includes emission and immunity aspects as they are wellknown for not-radio equipment. All ETSI standards including the one mentioned here are downloadable for free at ETSI.org after registration. Regards, Gert Gremmen ce-test, qualified testing Rotterdam, The Netherlands http://www.ce-test.nl -----Original Message----- From: [email protected] [mailto:[email protected]]On Behalf Of Kirk Thomas Sent: woensdag 11 december 2002 19:25 To: [email protected] Subject: Receiver Requirements in ETSI 300 220 In the title of ETSI 300 220 it states "Harmonized EN covering essential requirements under article 3.2 of the R&TTE Directive". Article 3.2 is only concerned that the device effectively uses the allocated spectrum, but within the standard it has a battery of receiver immunity tests. I thought that by completing ETSI 300 683 Electromagnetic Compatibility (EMC) standard for short range devices that we had shown compliance with the requirements of the EMC Directive. My question is this; Do I show compliance with the EMC Directive and the R&TTE Directive by complying to ETSI 300 683 and ETSI 300 220 (less the Receiver tests of ETSI 300 220)? Your comments would be greatly appreciated. Kirk Thomas ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: [email protected] Dave Heald: [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] All emc-pstc postings are archived and searchable on the web at: http://ieeepstc.mindcruiser.com/ Click on "browse" and then "emc-pstc mailing list" ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: [email protected] Dave Heald: [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] All emc-pstc postings are archived and searchable on the web at: http://ieeepstc.mindcruiser.com/ Click on "browse" and then "emc-pstc mailing list"
