EN 300220-1 contains the test requirements, but its reference is not published in the OJ. EN 300220-3 is published in the OJ and lists the sections of EN300220-1 that apply in order to comply with the essential requirements concerning article 3.2 of the RTTE Directive. As you noted, it lists requirements for the receiver as well as the transmitter. If you declare compliance using the standard, you will have to comply with all requirements of EN 300220-3. I once used the TCF route and the Notified Body told me that the blocking requirement was not an essential requirement. Go figure. Oh, and, of course you also have to comply with EN 300 683 or its replacement, EN 301489-1 and EN 301489-3.
Richard Woods Sensormatic Electronics Tyco International -----Original Message----- From: Kirk Thomas [mailto:[email protected]] Sent: Wednesday, December 11, 2002 1:25 PM To: [email protected] Subject: Receiver Requirements in ETSI 300 220 In the title of ETSI 300 220 it states "Harmonized EN covering essential requirements under article 3.2 of the R&TTE Directive". Article 3.2 is only concerned that the device effectively uses the allocated spectrum, but within the standard it has a battery of receiver immunity tests. I thought that by completing ETSI 300 683 Electromagnetic Compatibility (EMC) standard for short range devices that we had shown compliance with the requirements of the EMC Directive. My question is this; Do I show compliance with the EMC Directive and the R&TTE Directive by complying to ETSI 300 683 and ETSI 300 220 (less the Receiver tests of ETSI 300 220)? Your comments would be greatly appreciated. Kirk Thomas ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: [email protected] Dave Heald: [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] All emc-pstc postings are archived and searchable on the web at: http://ieeepstc.mindcruiser.com/ Click on "browse" and then "emc-pstc mailing list" ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: [email protected] Dave Heald: [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] All emc-pstc postings are archived and searchable on the web at: http://ieeepstc.mindcruiser.com/ Click on "browse" and then "emc-pstc mailing list"
