Hello All, If any members of this forum have any response copies that were sent out to John's question below, would you please forward a copy to me?
Thanks In Advance, Kaz Gawrzyjal [email protected] -----Original Message----- From: Kretsch, John [mailto:[email protected]] Sent: Wednesday, February 14, 2001 12:37 PM To: '[email protected]' Subject: Bellcore Redundancy Requirements? Does anyone in the collective know about _where_ Bellcore spells out any sort of redundancy requirements. There is a buzz about "L-10" requirements and I'm not sure where this comes from. TIA. Regards, John Kretsch ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Jim Bacher: [email protected] Michael Garretson: [email protected] For policy questions, send mail to: Richard Nute: [email protected] ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: [email protected] Dave Heald: [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] All emc-pstc postings are archived and searchable on the web at: http://ieeepstc.mindcruiser.com/ Click on "browse" and then "emc-pstc mailing list"
