Brian, You will 100% manufacturing tests (assuming they are required) in Appendix D of your UL Procedure The UL Appendix is in the front of the Procedure, and before the Section General.
(UL should have called it "Prefix" rather than "Appendix"!) Note that the UL Procedure contains the Appendix pages (instructions to the manufacturer and to the UL Inspector) and does not contain the product evaluation type tests. The UL Report has the same main content, but does not contain the Appendix pages, and it does contain the type tests performed on the product. Thus, the UL Report is the engineering evaluation and tests, and the UL Procedure is for the manufacturer and the field inspector. Tania Grant [email protected] ----- Original Message ----- From: "Brian O'Connell" <[email protected]> To: <[email protected]> Sent: Wednesday, January 23, 2002 12:59 PM Subject: 601-1 Factory Tests > > The good people of the PSTC group were very helpful last time; so I will go > to the well again... > > Other than the General section of my UL FUS procedures, I can find no > reference for required (100%) factory tests and test parameters. Is there an > IEC/EN60601-1 based factory test listing anywhere (normative or informative) > ? > > thanks much, > Brian O'Connell > Taiyo Yuden (USA), Inc. > > > ------------------------------------------- > This message is from the IEEE EMC Society Product Safety > Technical Committee emc-pstc discussion list. > > Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ > > To cancel your subscription, send mail to: > [email protected] > with the single line: > unsubscribe emc-pstc > > For help, send mail to the list administrators: > Michael Garretson: [email protected] > Dave Heald [email protected] > > For policy questions, send mail to: > Richard Nute: [email protected] > Jim Bacher: [email protected] > > All emc-pstc postings are archived and searchable on the web at: > No longer online until our new server is brought online and the old messages are imported into the new server. > ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Michael Garretson: [email protected] Dave Heald [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] All emc-pstc postings are archived and searchable on the web at: No longer online until our new server is brought online and the old messages are imported into the new server.
