Hi Arno, John gave you the short answer...the MFG should have installation instructions. In all of the installation I have been party, there is a grid of copper tape laid down in the conductive adhesive. This keeps the adhesive from getting excessively resistive over large areas. Surface resistance tests run anywhere from 100k-400k ohms when it's all done. Note that if you are installing relay racks or metal benches that you can run into ground loops. Have a Great Day, Dave Spencer Oresis Communications
-----Original Message----- From: Arno van Kesteren To: Arno van Kesteren; [email protected] Sent: 3/18/02 1:48 PM Subject: Earthing of conductive floor tiles Dear Group, Do conductive tiles in floors for ESD prevention have to be connected together (e.g. through a low impedance earth bond) ? Arno van Kesteren ESO Munich, Germany e-mail: [email protected] ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: [email protected] Dave Heald: [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] All emc-pstc postings are archived and searchable on the web at: http://ieeepstc.mindcruiser.com/ Click on "browse" and then "emc-pstc mailing list" ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: [email protected] Dave Heald: [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] All emc-pstc postings are archived and searchable on the web at: http://ieeepstc.mindcruiser.com/ Click on "browse" and then "emc-pstc mailing list"
