Hi,
I have used this lab to calibrate my antennas. It was not as expensive an
you might think. And, they do good work with reasonable turn-around times.
They might even be able to help you without doing calibrations. But if you
are going to use the antennas for any measuring work, then best to get them
calibrated at least once.
Scott
At 04:59 PM 6/28/02 +0100, Barker, Neil wrote:
I would suggest that you will need to contact the manufacturers who may be
able to provide "typical" antenna factors.
However, at best these will just be close approximations to your actual
antennas. The only surefire answer is to have your antennas calibrated. I
know that this can be costly, but not only will the results be known to
within a given measurement uncertainty, but also any latent problems will be
identified so that your confidence in your equipment is enhanced.
Best regards,
Neil R. Barker
Compliance Engineering Manager
Marconi Applied Technologies Ltd.
106 Waterhouse Lane
Chelmsford
Essex
CM1 2QU
U.K.
Tel: +44 (01245) 453616
Fax: +44 (01245) 453410
E-mail: [email protected]
> -----Original Message-----
> From: [email protected] [mailto:[email protected]]
> Sent: 28 June 2002 15:49
> To: [email protected]
> Subject: Need Antenna Factors
>
>
>
> I need to obtain "generic" antenna factors for the EMCO 3146A Log
> Periodic and Eaton 94455-1 Biconical Antenna's. I have tried
> manufacturer's
> Web sites but to no avail. Are there some toher Web Sites
> that might be
> helpful?
>
> Jim Paolantonio
> Sounds of Silence EMC LLC
> [email protected]
>
> -------------------------------------------
> This message is from the IEEE EMC Society Product Safety
> Technical Committee emc-pstc discussion list.
>
> Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/
>
> To cancel your subscription, send mail to:
> [email protected]
> with the single line:
> unsubscribe emc-pstc
>
> For help, send mail to the list administrators:
> Ron Pickard: [email protected]
> Dave Heald: [email protected]
>
> For policy questions, send mail to:
> Richard Nute: [email protected]
> Jim Bacher: [email protected]
>
> All emc-pstc postings are archived and searchable on the web at:
> http://ieeepstc.mindcruiser.com/
> Click on "browse" and then "emc-pstc mailing list"
>
-------------------------------------------
This message is from the IEEE EMC Society Product Safety
Technical Committee emc-pstc discussion list.
Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/
To cancel your subscription, send mail to:
[email protected]
with the single line:
unsubscribe emc-pstc
For help, send mail to the list administrators:
Ron Pickard: [email protected]
Dave Heald: [email protected]
For policy questions, send mail to:
Richard Nute: [email protected]
Jim Bacher: [email protected]
All emc-pstc postings are archived and searchable on the web at:
http://ieeepstc.mindcruiser.com/
Click on "browse" and then "emc-pstc mailing list"
Senior Compliance Engineer
Narad Networks
515 Groton Road
Westford, MA 01886
office: 978 589-1869
cell: 978-239-0693
[email protected]
www.naradnetworks.com
