The resistance is about 20 ohms, and not 10 ohms. Now you needed 400 volts to obtain 20 amps through the two coils in series. Or, run them in parallel with 200 volts. This might be off a bit but I get 5 mN for the force between the two coils. So, they aren't going to tear the setup apart. Almost a 5000 foot spool of wire needed per coil. This looks like a fun project.
Dave Cuthbert This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: [email protected] Dave Heald: [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] All emc-pstc postings are archived and searchable on the web at: http://ieeepstc.mindcruiser.com/ Click on "browse" and then "emc-pstc mailing list"
