Thanks to all that replied. One comment: I looked at a manual from a similar product and in their manual ONLY the Manf name and address is listed. They did NOT include a person or a title. I guess that was the thrust of my question. I am trying to understand the details of the requirement. Is a persons name and title required? Best Regards Charles Grasso Senior Compliance Engineer Echostar Communications Corp. Tel: 303-706-5467 Fax: 303-799-6222 Cell: 303-204-2974 Email: charles.gra...@echostar.com; <mailto:charles.gra...@echostar.com; > Email Alternate: chasgra...@ieee.org
From: Pettit, Ghery [mailto:ghery.pet...@intel.com] Sent: Thursday, April 17, 2003 2:14 PM To: Grasso, Charles; emc-p...@majordomo.ieee.org Subject: RE: Q. on responsible party for FCC CLass B FCC Rules, Part 2.909, defines the "responsible party" "§2.909 Responsible party. - The following parties are responsible for the compliance of radio frequency equipment with the applicable standards: (a) In the case of equipment which requires the issuance by the Commission of a grant of equipment authorization, he party to whom that grant of authorization is issued (the grantee). If the radio frequency equipment is modified by any party other than the grantee and that party is not working under the authorization of the grantee pursuant to §2.929(b), the party performing the modification is responsible for compliance of the product with the applicable administrative and technical provisions in this chapter. (b) In the case of equipment subject to authorization under the verification procedure, the manufacturer or, in the case of imported equipment, the importer. If subsequent to manufacture and importation, the radio frequency equipment is modified by any party not working under the authority of the responsible party, the party performing the modification becomes the new responsible party. (c) In the case of equipment subject to authorization under the Declaration of Conformity procedure: (1) The manufacturer or, if the equipment is assembled from individual component parts and the resulting system is subject to authorization under a Declaration of Conformity, the assembler. (2) If the equipment, by itself, is subject to a Declaration of Conformity and that equipment is imported, the importer. (3) Retailers or original equipment manufacturers may enter into an agreement with the responsible party designated in paragraph (c)(1) or (c)(2) of this section to assume the responsibilities to ensure compliance of equipment and become the new responsible party. (4) If the radio frequency equipment is modified by any party not working under the authority of the responsible party, the party performing the modifications, if located within the U.S., or the importer, if the equipment is imported subsequent to the modifications, becomes the new responsible party. (d) If, because of modifications performed subsequent to authorization, a new party becomes responsible for ensuring that a product complies with the technical standards and the new party does not obtain a new equipment authorization, the equipment shall be labelled, following the specifications in §2.925(d), with the following: "This product has been modified by [insert name, address and telephone number of the party performing the modifications]." " Could be you, if the company assigns you the responsibility and authority to sign for them. Ghery Pettit From: Grasso, Charles [mailto:charles.gra...@echostar.com] Sent: Thursday, April 17, 2003 10:11 AM To: emc-p...@majordomo.ieee.org Subject: Q. on responsible party for FCC CLass B Hi all, The FCC requires the name and address for the responsible party. (akin to the EU signatory for the DoC) . Who would that be?? Best Regards Charles Grasso Senior Compliance Engineer Echostar Communications Corp. Tel: 303-706-5467 Fax: 303-799-6222 Cell: 303-204-2974 Email: charles.gra...@echostar.com; <mailto:charles.gra...@echostar.com; > Email Alternate: chasgra...@ieee.org
