I am wondering if any of you have had experience using a current probe to
inject current into a power line for a modified MIL-STD-461 CS101 test?
I am trying to envision how I am going to run CS101 on a 150 Amp system
without blowing up the test equipment amplifiers. I cannot use two
identical transformers and two identical loads to help protect the
amplifiers.
Thanks
Aaron
Aaron S. Low
Systems Engineer
Naval Electronics and Surveillance Systems
EP5 D5 MD45 Syracuse, NY 13221-4840
Phone: (315) 456-1203 Fax: (315) 456-0509
This message is from the IEEE EMC Society Product Safety
Technical Committee emc-pstc discussion list.
Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/
To cancel your subscription, send mail to:
[email protected]
with the single line:
unsubscribe emc-pstc
For help, send mail to the list administrators:
Ron Pickard: [email protected]
Dave Heald: [email protected]
For policy questions, send mail to:
Richard Nute: [email protected]
Jim Bacher: [email protected]
Archive is being moved, we will announce when it is back on-line.
All emc-pstc postings are archived and searchable on the web at:
http://www.ieeecommunities.org/emc-pstc
