I would like to know if anyone out there has had any experience with running
CS101 on very high pulsed current devices.
Our EUT (class AB amplifier) draws > 150 A (115 VAC 400 Hz). I would like
to know what equipment and methods were used.
On a related note, this equipment cannot be operated with the standard 50 uH
LISN, but a 5 uH LISN cannot be used to measure below 100 kHz. Has anyone
used the voltage probe method defined in the appendix of 461E?
Thanks
Aaron
Aaron S. Low
Systems Engineer
Naval Electronics and Surveillance Systems
EP5 D5 MD45 Syracuse, NY 13221-4840
Phone: (315) 456-1203 Fax: (315) 456-0509
L
This message is from the IEEE EMC Society Product Safety
Technical Committee emc-pstc discussion list.
Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/
To cancel your subscription, send mail to:
[email protected]
with the single line:
unsubscribe emc-pstc
For help, send mail to the list administrators:
Ron Pickard: [email protected]
Dave Heald: [email protected]
For policy questions, send mail to:
Richard Nute: [email protected]
Jim Bacher: [email protected]
Archive is being moved, we will announce when it is back on-line.
All emc-pstc postings are archived and searchable on the web at:
http://www.ieeecommunities.org/emc-pstc
