Doug, do you mean the only the substrate or a PCB with the copper and soldermask in place? Regards, Lou Aiken, LaMer LLC 27109 Palmetto Drive Orange Beach, AL 36561 USA tel ++ 1 251 981 6786 fax ++ 1 251 981 3054 Cell ++ 1 251 979 4648
----- Original Message ----- From: POWELL, <mailto:[email protected]> DOUG To: EMC-PSTC (E-mail) <mailto:[email protected]> Sent: Thursday, June 19, 2003 11:47 AM Subject: PCB marked for UL 94V-0 Hello group, An interesting question came up about validating printed circuit board raw material. In searching for alternate vendors we provide a spec that V-0 material is required and a UL V-0 stamp be placed on the board. The question is, how do I independently validate the material used, since a vendor could theoretically choose whatever they want and stamp it as V-0? -doug Douglas E. Powell Regulatory Compliance Engineer Advanced Energy Industries, Inc. Fort Collins, CO 80535 USA _______________________________________________________________ This message, including any attachments, may contain information that is confidential and proprietary information of Advanced Energy Industries, Inc. The dissemination, distribution, use or copying of this message or any of its attachments is strictly prohibited without the express written consent of Advanced Energy Industries, Inc.
