From: [email protected] Reply-To: [email protected] List-Post: [email protected] List-Post: [email protected] List-Post: [email protected] List-Post: [email protected] Date: Wed, 18 Jun 2003 20:13:25 EDT > Also, there is a chain-link fence running parallel with the proposed site, > but the fence is just outside the ellipse. Would there be any problems > with site attenuation?
The fence may not be an important factor if it is not 'too' high. Ken is right, first do a simple site survey. I suggest you use a roll of chicken wire (mesh) to check out the site first. (ANSI C63.7-1992 page 5.) To be realistic, try to keep the reference plane within +/- 4.5 cm flat. However all things being said, that will largely depends on the soil's mechnical condition. By right :-) only low bushes are acceptable in the immediate 'vicinity' of the ellipse (obstruction free area). Another way is to do a NEC (MOM) simulation to see if the fence have a significant contribution NSA of the OATS. :-) Good luck. Tim Foo This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: [email protected] Dave Heald: [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] Archive is being moved, we will announce when it is back on-line. All emc-pstc postings are archived and searchable on the web at: http://www.ieeecommunities.org/emc-pstc
