At the risk of collecting the ire of the instrument
manufacturers, look at buying an "up to 500MHz" network
analyzer. Do an in house demonstration.
- Robert -
Robert A. Macy, PE .. [email protected]
408 286 3985 . . . .. . . fx 408 297 9121
AJM International Electronics Consultants
101 E San Fernando, Suite 402
San Jose, CA 95112
On Thu, 18 Dec 2003 10:40:09 -0700
"Grasso, Charles" <[email protected]> wrote:
> Greetings all:
>
> I have a requirement to test the performance of ferrite
> bead (one that
> that can fit over a power cord) to 500MHz for
> qualification of
> alternate vendors.
>
> I have an impedance analyser - but it only goes to 40MHz.
> Does anyone
> have a good way to verify ferrite impedance.??
>
> Thanks
>
> Best Regards
> Charles Grasso
> Senior Compliance Engineer
> Echostar Communications Corp.
> Tel: 303-706-5467
> Fax: 303-799-6222
> Cell: 303-204-2974
> Email: [email protected];
> <mailto:[email protected]; >
>
> Email Alternate: [email protected]
> <mailto:[email protected]>
>
>
This message is from the IEEE EMC Society Product Safety
Technical Committee emc-pstc discussion list.
Visit our web site at: http://www.ieee-pses.org/
To cancel your subscription, send mail to:
[email protected]
with the single line:
unsubscribe emc-pstc
For help, send mail to the list administrators:
Ron Pickard: [email protected]
Dave Heald: [email protected]
For policy questions, send mail to:
Richard Nute: [email protected]
Jim Bacher: [email protected]
All emc-pstc postings are archived and searchable on the web at:
http://www.ieeecommunities.org/emc-pstc
